RadiSys ATCA-5400 RTM Especificaciones descargar pdf (Pagina 171)

171

GCONFIGURE iSCSI BOOT

ThisappendixdescribeshowtoconfigureaniSCSIbootdevice.ItappliestoanATCA‐4500,

ATCA‐4550,orATCA‐4555CPMwithaniSCSIstoragemoduleinstalledinthesameshelf.

TheseprocedureswerepreparedusinganAstuteCaspianR1100iSCSIstoragemodule.

DependingonthespecificiSCSImodule,thecommandsanddisplayedinformationmay

differfromwhatispresentedintheseprocedures.TheoperatingsystemtoinstallisRed

HatEnterpriseLinux5.464‐bit,orgreater.

System requirements and configuration

ThefollowingitemsarerecommendedforcompletingtheiSCSIbootprocedure.

•AproperlyconfigurediSCSItargetavailableontheCPMFabricnetwork

•OneormoreCPMs

•TwoATCA‐2210switchandcontrolmodules

•A14‐slotor16‐slotATCAshelf

•AbootableUSBDVDdrive

• InstallationmediaforRedHatEnterpriseLinuxversion5.464‐bit,orgreater

•APromentumsoftwareinstallationCDwiththelatestCPMRPMs

•Ashelfmanagementorheadsystemcapableofprovidingserialconnections

Implement iSCSI boot

TheseproceduresconfigureiSCSIbootfortheATCA‐4500,ATCA‐4550,orATCA‐4555.

Configure the CPM hardware and BIOS

1. OptionallyremoveallRTMsandAMCharddrives.

2. ConnectaterminaltotheCPMserialport.

3. ConnectaUSBDVDROMdrivetotheUSB0portontheCPM.

4. BoottheCPM.EntertheBIOSbypressingF2whenprompted.

5. IntheBIOSAdvancedmenu,setLaunchNetworkOpROMtoiSCSI.

6. IntheIPMImenu,setthesewatchdogoptionstoDisable:

•POSTWatchdog

•O/SWatchdogTimer

7. SelectSavechangesandreset.

1 2 ... 166 167 168 169 170 171 172 173 174

Sin comentarios

RadiSys ATCA-5400 RTM Especificaciones Pagina 171