RadiSys ATCA-5400 RTM Manual de usuario descargar pdf (Pagina 6)

Release Notes

ethtool shows Speed: Unknown! (10000) on Fabric interfaces

Using ethtool or rsys-ethtool on the Fabric (Oplin) interfaces on any OS build, "Speed:

Unknown! (10000)" is returned for the speed of the interface. This does not occur using

version 6 of ethtool.

Workaround: Upgrade to ethtool version 6. Contact your OS vendor for information on

this upgrade.

Resolution: Contact your OS vendor for the upgrade to ethtool version 6 or later.

Issue No: RSYS00048264

Local ipmitool firmware upgrades are much slower in MontaVista CGE 4.0

Upgrades of the ATCA-4500 IPMC firmware are very slow under MontaVista CGE 4.0. Given

time to complete, there is no observed operational impact.

Workaround: None.

Resolution: This issue will be addressed in a future release.

Issue No: RSYS00048380

BIOS intermittently hangs at POST B4 when a bad USB CD/DVD drive or bad media is used

When a USB CD/DVD drive is attached to the system, the BIOS may hang at post code B4 if it

cannot read the media in the drive. This can occur when a drive is failing, the media in the drive

is bad, or when a USB bus-powered drive is attached but is not receiving sufficient power.

Workaround: Remove the DVD media, boot the ATCA-4500, then insert the disk into the

DVD drive only after the board has booted into the OS.

If you are using a bus-powered drive, attach external power to use a dual-

port USB power cable. If you are using writable media, such as a CD-R or

DVD-R, create a new CD or DVD.

Resolution: This issue may be addressed in a future release.

Issue No: RSYS00048540

PXE Boot is not supported on RTM SFP ports

PXE Boot is not supported on the ATCA-5400 RTM SFP ports, or on any other SFP that operates

in SGMII mode.

Workaround: None.

Resolution: This issue may be addressed in a future release.

Issue No: RSYS00048603

Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com

1 2 3 4 5 6 7 8 9 10 11

Sin comentarios

RadiSys ATCA-5400 RTM Manual de usuario Pagina 6